Retro AR15 Extended Flash Hider 5/8-24 - 6 Inch
Retro AR15 Extended Flash Hider - 6 Inch - 5/8-24
Design inspired by the XM-177 Moderator, this extended flash hider will extend a 10.5" barrel to legal non-NFA length when pin and welded.
- CNC machined from bar steel
- Heat treated for strength
- Phosphate coated to protect from corrosion
- Threaded 5/8-24
- Bore sized for use on all 5.56mm, 9mm, and 45 / 458 cal barrels
- 5 flash hiding ports, sealed bottom similar to an A2 flash hider
- 6.15" over all length
- 1.0" diameter
- Adds approximately 5.56" to overall length of barrel when pinned and welded.
- .125" hole pre-drilled for pin and weld
- Weight: 9.7oz
- Requires standard .750" wrench for installation
Write Your Own Review